Filter
Top Products
5312/5324 IP Phones User Guide
Call Park
The Call Park feature allows you to place a call in a special hold state. You, or someone else, can
then retrieve the call from any extension in the system. After parking the call, the system can
automatically connect you to paging equipment so that you can announce the call to the requested
party.
To park an active call:
1. Do one of the following:
• Press the Call Park feature key (must be programmed)
• Press
( TRANS/CONF ), and then dial *7#. The display shows PARKED@, followed
by the park destination and parking spot index (if applicable). Example: PARKED@ 1234 @
02.
2. Dial the directory number on which to park the call (not required if the number is programmed to
the Call Park feature key).
3. To inform a user that a parked call is waiting, do one of the following:
• If automatic paging is enabled, announce the call and the park retrieve digits shown on the
display.
• If automatic paging is disabled, press the programmed Page key, or dial **9, followed by the
Paging zone number (if required). Then, announce the call and park retrieve digits shown on
the display.
Note: Paging over a loudspeaker is not permitted in handsfree mode; you must use the handset
or headset.
To retrieve a parked call:
1. Do one of the following:
• Dial the appropriate feature access code.
• Press the Call Park - Retrieve feature key (must be programmed).
2. Dial the directory number on which the call is parked (not required if the number is programmed
to the Call Park feature key).
3. If there are multiple calls parked on the number, dial the two-digit index number to retrieve a
specific call, or # to retrieve the longest parked call.
Call Pickup
To answer a call that is ringing at another phone in your Pickup Group:
1. Lift the handset.
2. Press the Pickup feature key or the Pickup softkey.
To answer a call that is ringing at a station not in your Pickup Group:
1. Lift the handset.
2. Dial the appropriate feature access code.
3. Dial the number of the ringing station.
22