Filter
Top Products
-77-
To switch between the current call and the held call when one of the
calls is using the analog line, do one of the following:
z
If your current call is using the analog line, press the flashing Line key of
the held call. The analog call is automatically put on hold.
z
If your current call is using an IP line, press the highlighted Line Interface
Module key. The IP line is automatically put on hold.
To end a current call when an incoming analog call arrives:
z Press Cancel ( ) and then press the highlighted Line Interface Module
key. The current call ends and you are connected to the caller on the
analog line.
To end the current analog call when an incoming call arrives:
z
Press Cancel ( ). The current analog call ends and you are connected
to the new caller.
Making and Answering Calls Using the Failover Mode
To make a call using the analog line during an IP connection failure:
1. Lift the handset.
The phone displays IP FAIL: ANALOG CALL.
2. Dial the number.
To answer a call using the analog line during an IP connection failure:
z
Lift the handset. The call is answered.
The phone displays IP FAIL: ANALOG CALL.