Filter
Top Products
-66-
Tag Call
Tag Call allows you to signal that you are the victim of a threatening or
malicious call. Using the tag, your system administrator or Telephone
Company can identify the source of the call and provide this information to
appropriate personnel or authorities.
CAUTION: Tagging a non-malicious call may result in fines or other
penalties.
To tag a malicious call:
1. Press the programmed Tag Call key while the call is in progress. For
information on how to program keys, see to Programming Features On
Your Keys -OR-
2. Press Trans/Conf.
3. Dial the appropriate feature access code.
If the call was successfully tagged, Thank You is shown on the display;
otherwise, Not Allowed is displayed.
Note: Tag Call can be used on active two-party calls only. Calls on hold
and conference calls cannot be tagged.
USING THE 5235 IP PHONE WITH 5310 IP
CONFERENCE UNIT
The 5235 IP Phone uses the 5310 IP Conference Unit for conferencing. You
use the Conference Controller to turn the conference unit off or on, to ad
j
ust
the volume or to put the conference unit into Presentation mode. You can
only run one Conference Controller session at a time. If the 5310 Conference
Unit is not connected to the 5235, the Conference Controller application is
not available.