Filter
Top Products
-3-
Adjusting the viewing angle
The stand built into your 5235 IP Phone tilts to give you a better view of the
keys.
To adjust the viewing angle:
1. Disconnect the cables to your phone.
2. Depress the button on both sides of the stand at the back of the phone to
remove the stand.
3. Hinge the hooks on the base unit into the notches on the back of the
phone and snap into place as follows:
For a high-angle mount, hinge the two lower hooks into the bottom
set of notches and snap the two upper hooks into the middle set of
notches.
For a low-angle mount, hinge the two lower hooks into the middle set
of notches and snap the two upper hooks into the top set of notches.
Note: For more information about adjusting the viewing angle of your
phone, refer to the 5235 IP Phone Installation Guide shipped with your
phone.