Filter
Top Products
21
For a more detailed list of Analog Adjunct (Tip/Ring) status light indications, see
“PassageWay and Analog Adjunct Status Indications on the 8411” earlier in this
manual.
To enable or disable the status lights for the Analog Adjunct interface
1. While on-hook, press .
• The light next to goes on.
2. Press .
• The light next to goes off.
3. Enter the 2-digit code, “25” (“AL”).
• The red and green lights next to Button #10 flutter.
• The current setting (ENABLE T/R STATUS LAMPS or
DISABLE T/R STATUS LAMPS) is shown on the display, if there is one.
4. Press either “1” or “2” to change the setting:
• Press “1” to enable the status lights for the Analog (Tip/Ring) Adjunct
connected to the Analog Adjunct jack
• Press “2” to disable status lights for Analog Adjunct connection (so the
button is thus used in the normal way, that is, for call appearance or feature
indications)
or if the voice terminal has a display, press to change the setting. Press
to save the desired option and then exit programming.
• After pressing “1” or “2” or pressing , the light next to goes
off and one of the following voice terminal responses occurs:
If the voice terminal saves your selection, the first three green call
appearance lights go on and, if you have a display, a confirmation
message is displayed.
If the voice terminal cannot save this selection, the first three red call
appearance lights go on and, if you have a display, an error message is
displayed. In this case, the selected option will be in effect until power is
removed from the set. If this happens, try repeating the process. If the
option still cannot be saved, the terminal may be faulty.
Shift
Shift
Mute
Shift
*
#
#
Shift