Filter
Top Products
15
WARNING: Do NOT connect the Analog Adjunct to the wall jack. It will
cause equipment damage.
NOTE: When an 8411 voice terminal is administered at a DEFINITY G3V4, Issue 3,
switch, the voice terminal must be administered to use the appropriate analog
telephone line. For more information on administration of the 8411, see “Switch
Administration” later in this manual.
PassageWay and Analog Adjunct Status Indications on the 8411
The system manager may choose to administer Buttons #9 and #10 on the 8411 voice
terminal, the last two buttons in the second column as shown in Figure 10, so that the
lights next to these buttons show the status of the PassageWay connection (the PC
can be connected to the RS-232-D jack on the rear of the 8411) and the status of the
Analog Adjunct (this adjunct equipment can be connected to the Analog Adjunct jack
also on the rear
of the 8411).
NOTE: Button #9 is always used to monitor PassageWay, and Button #10 is always
used to monitor the status of the Analog Adjunct.
IMPORTANT: At any time, you may use the Diagnostic feature (press and
then to enter Diagnostic Mode) to view the status light indications (next to
Buttons #9 and #10) of the PassageWay and the Analog Adjunct connections.
FIGURE 10: The location of Buttons #9 and #10 on the 8411
Shift
Test
1
2
3
4
5
6
7
8
9
10
These lights are used for
PassageWay status
These lights are used for
Analog Adjunct status