Filter
Top Products
20
To select which channel (the I-1 Channel or the I-2 Channel) the Analog
(T/R) Adjunct will use
1. While on-hook, press .
• The light next to goes on.
2. Press .
• The light next to goes off.
3. Enter the 2-digit code, “42” (“IC”).
• The red light next to flutters.
• The current setting (either T/R ON I1 CHANNEL or T/R ON I2
CHANNEL) is shown on the display, if there is one.
4. Press either “1” or “2” to change the setting:
• Press “1” to select the I-1 Channel for Analog Adjunct transmission
• Press “2” to select the I-2 Channel for Analog Adjunct transmission
or if the voice terminal has a display, press to change the setting. Press
to save the desired option and then exit programming.
• After pressing “1” or “2” or pressing , the light next to goes
off and one of the following voice terminal responses occurs:
If the voice terminal saves your selection, the first three green call
appearance lights go on and, if you have a display, a confirmation
message is displayed.
If the voice terminal cannot save this selection, the first three red call
appearance lights go on and, if you have a display, an error message is
displayed. In this case, the selected option will be in effect until power is
removed from the set. If this happens, try repeating the process. If the
option still cannot be saved, the terminal may be faulty.
Enabling/Disabling the Status Lights for the Analog (Tip/Ring) Adjunct
Interface (For the 8411 Only)
If an Analog Adjunct has been connected to the Analog Adjunct jack on the rear of
the 8411 voice terminal, the user can use the lights next to Button#10 (the last button
in the second column) to see the status of the Analog Adjunct connection. These
indications show:
• Status of the ringing signal being sent from the voice terminal to the Analog
Adjunct) (on OR off)
• Switchhook status of the Analog Adjunct (off-hook OR on-hook and idle)
• Status of the I-Channel (used by the Analog Adjunct OR by the 8411 voice
terminal)
Shift
Shift
Mute
Shift
Shift
*
#
#
Shift