Filter
Top Products
6
FIGURE 4: Line, Adjunct, Handset, and Expansion Module Cord Routing on the
8434DX Voice Terminal
7. Turn the voice terminal right side up, with the front facing you.
8. Snap the free end of the handset cord into the handset and place the handset in
the cradle.
9. Snap the free end of the line cord into the modular wall jack.
Refer to the section, “Attaching Adjunct Equipment” for information about
connecting an 8400-Series voice terminal to the wall jack when an adjunct is
used.
10. Lift the handset and listen for dial tone. If there is no dial tone, check all wire
connections to make sure they are secure. Also, perform a self-test to see if the
terminal is receiving power. (Press and hold down the button. If the
light next to the button flashes rather than goes on steadily, it means the
terminal is not able to communicate with the switch. If the Test light does not go
Adjunct
Handset
Line jack
> ABS<
NOTE: The location of the jacks and the routing channel
USE ONLY WITH
COMMUNICATION
CIRCUIT POWER
SOURCE
!
U
L
LISTED
91B0
Telephone
Equipment
®
HAC
Lucent Technologies
MADE IN U.S.A.
Expansion
module jack
on the back of your voice terminal may differ slightly
from the location shown in this figure.
Routing channel
EX MOD
LINE
jack
jack
Test