Filter
Top Products
52
11
DIGITAL MODE OPERATION
■ Repeater call sign programming
Repeater call sign must be programmed for repeater opera-
tion in both digital voice and low speed data communications.
q Push [A•
FUNC
] and [0•
OPT
] to enter
OPTION SET MODE
, then
push [
YY
] or [
ZZ
] several times to select the call sign items.
• “R1C” or “R2C” appears for repeater call sign.
w Push and hold [0•
OPT
] for 1 sec. then rotate [VOL] to se-
lect the desired call sign channel.
e Push [
YY
] to select call sign programming mode.
• The 1st digit blinks and channel indication stops blinking.
r Rotate [VOL] to set the desired character or code.
• Push [
ZZ
] or [
YY
] to move the cursor to left or right, respectively.
t Push [
YY
] to select 2nd digit, then rotate [VOL] to set the
desired character or code.
• 2nd digit blinks (1st digit stop blinking).
• Repeat this step for programming repeater call sign.
y Push [0•
OPT
] to save the call sign.
u Rotate [VOL] to select an another channel from “C1” to
“C6.”
i Repeat steps w to u to program other repeater call sign
channels.
✔
For your information:
Station and/or repeater call sign can be programmed from
Received call record when a call is received.
See page 46 for details.
✔
For your information:
Repeater call sign can be programmed for gateway connec-
tion capabilities at step r for connecting to the another Area
or Zone.
•“G” appears or disappears as the 8th digit when pushing [8•
SET
].
While using the repeater 2 (other Area or Zone) system, the
repeater 2 setting must be selected ON in
OPTION SET MODE
.
• “R2C” (Repeater 2 call sign) can be programmed or used when
“RP2” (Repeater 2 setting) is set to ON (default).