Filter
Top Products
27
7
DTMF MEMORY
6
7
■ Programming a DTMF code sequence
The transceiver has 16 DTMF memory channels (d0 to dF)
for storage of often-used DTMF code sequence of up to 24
digits. DTMF memories are used to store phone numbers or
control codes.
qPush [A•
FUNC
], then push [0•
OPT
] to enter
OPTION SET MODE
.
• Rotate [VOL] to select “dtm.OF,” if necessary. Or when an op-
tional UT-118
DIGITAL UNIT
is installed, push [
YY
] or [
ZZ
] several
times until “dtm.OF” appears.
wPush and hold [0•
OPT
] for 1 sec. to select the DTMF memory.
• One of “d0” to “dF” appears.
e
Rotate [VOL] to select the desired DTMF memory.
rPush and hold [0•
OPT
] for 1 sec. to enter the DTMF pro-
gramming mode.
•“_____” appears.
• Programmed memories can be cleared in this way.
tEnter the desired DTMF code sequence by pushing the
digit keys, [A•
FUNC
], [B•
CALL
], [C•
MR
], [D•
CLR
], [#•
BANK
]
and [✱•
ENT
], in the desired sequence.
•Amaximum of 24 digits can be input.
• [✱•
ENT
] enters tone “E”, [#•
BANK
] enters tone “F.”
• If a digit is mistakenly input, push [MONI] or [PTT] momentarily
then repeat from step q.
yPush [MONI] or [PTT] to save the digits and exit the DTMF
programming mode.
• Programmed DTMF code sequence sounds when [MONI] is
pushed.
• Or after 24th digit is input, the transceiver automatically saves
the digits and returns to step w.
CALL
DUP SCAN
PRIO
ENT
SET
H/M/L
OPTSKIP
BANK
TONE
T. SCANP. BEEP
MR CLRFUNC
987
4
123
AB DC
560
OPT
0
Push for 1 sec.
OPT
0
Push for 1 sec.
FUNC
A
OPT
0
Push