Filter
Top Products
FM-4000Page 48
want to communicate on, then press the
[
ENT
]
key.
6. Press the
[
ENT
]
key again to transmit the Group
call signal.
7. When the Group call signal is sent, the LCD
displays the information shown in the illustra-
tion at right.
8. After the Group call is transmitted, all the ra-
dios in the group switch to the designated chan-
nel.
9. Listen to the channel to make sure it is not busy,
then key the microphone and call the other ves-
sels you desire to communicate with.
Manual Calling
You may enter a Group MMSI number manually to contact a group whose
Group call number is not registered in the radio.
1. Press the
[
CALL
(
MENU
)]
key to show the “
DSCDSC
DSCDSC
DSC
Call MenuCall Menu
Call MenuCall Menu
Call Menu.”
2. Turn the CHANNEL selector knob to select
“
GroupGroup
GroupGroup
Group.” (To cancel, press the
[
CLR
]
key.)
3. Press the
[
ENT
]
key. The transceiver beeps
then the “Group Directory” appears.
4. Turn the CHANNEL selector knob to select
“
ManualManual
ManualManual
Manual,” then press the
[
ENT
]
key.
5. Enter the MMSI number (nine digits: first digit per-
manently set to “0”) which you want to contact, then
press the
[
ENT
]
key.
6. If you enter a wrong number in the MMSI number,
press the
[
H/L
]
key until the wrong number is se-
lected, then enter the correct number.
7. When you have finished entering the MMSI
number, press and hold the
[
ENT
]
key.
8. Turn the CHANNEL selector knob to select
“
ManualManual
ManualManual
Manual,” then press the
[
ENT
]
key.
9. Turn the CHANNEL selector knob to select the op-
erating channel you want to communicate on, then
press the
[
ENT
]
key.
10. Press the
[
ENT
]
key again to transmit the Group
call signal.