Filter
Top Products
FM-4000Page 42
The Individual call and Group call ringers can be disabled as follows:
1. Press and hold down the
[
CALL
(
MENU
)]
key
until “
Radio SetupRadio Setup
Radio SetupRadio Setup
Radio Setup” menu appears.
2. Turn the CHANNEL selector knob to select the
“
DSC SetupDSC Setup
DSC SetupDSC Setup
DSC Setup” menu.
3. Press the
[
ENT
]
key, then use the CHANNEL
selector knob to select “
DSC BeepDSC Beep
DSC BeepDSC Beep
DSC Beep.”
4. Press the
[
ENT
]
key.
5. Turn the CHANNEL selector knob to select “
In-In-
In-In-
In-
dividualdividual
dividualdividual
dividual” if you wish to disable the Individual call
ringer, or “
GroupGroup
GroupGroup
Group” if you wish to disable the Group
call ringer and press the
[
ENT
]
key.
6. Turn the CHANNEL selector knob to select “
OffOff
OffOff
Off.”
7. Press the
[
ENT
]
key to store the selected setting.
8. Press the
[
CLR
]
key twice to return to the “
RadioRadio
RadioRadio
Radio
SetupSetup
SetupSetup
Setup” menu, then press the
[
CLR
]
key again to re-
turn to radio operation.
To enable the Individual or Group ringer tone, select “
OnOn
OnOn
On” in step “6” in this
procedure.
11.5.4 Transmitting an Individual Call
The Individual call feature allows you to contact another vessel that has a DSC
radio. This feature is similar to calling a vessel on CH16 and requesting to go
to another channel.
Using Pre-Programmed Vessel
1. Press the
[
CALL
(
MENU
)]
key to show the “
DSCDSC
DSCDSC
DSC
Call MenuCall Menu
Call MenuCall Menu
Call Menu”.
2. Turn the CHANNEL selector knob to select “
In-In-
In-In-
In-
dividualdividual
dividualdividual
dividual.” (To cancel, press the
[
CLR
]
key.)
3. Press the
[
ENT
]
key. The transceiver beeps
then the “Individual directory” appears.
4. Turn the CHANNEL selector knob to select the
“Individual” you want to contact.
5. Press the
[
ENT
]
key, then turn the CHANNEL
selector knob to select the operating channel
you want to communicate on, then press the
[
ENT
]
key.
6. Press the
[
ENT
]
key again to transmit the individual
DSC signal.