Filter
Top Products
~25~
B. Broadcasting from Base to Handset
1. Broadcast to all handsets
a. Press Broadcast key on the base station to
broadcast to all registered handsets.
b. After hearing bi-bi-beep signal; begin broadcast
message.
c. The Broadcast LED will light up.
d. Press the Broadcast key again and return to
IDLE mode.
C. Broadcasting from Handset to Base
1. Broadcast to the base station
a. Enter the Base ID and then press
“BROADCAST” key.
b. After hearing bi-bi-beep signal; begin broadcast
message.
c. The related base, within communication range
of initiating handset, will receive the broadcast.
d. Press the END key to end the broadcasting.
Redial
1.
Press REDIAL (Left) soft key.
2.
The LCD shows the last phone number dialed. To dial this number,
press DIAL (Left) soft key.
3.
Use Up or Down Arrow Key to scroll through the last 10 phone numbers
dialed. Select and press DIAL key.
[Note] Intercom numbers (Handset ID) are not stored in the last 10
numbers dialed log.
Receiving a Telephone Call
1. When an incoming call arrives, the ringer will ring or vibrate unless the
ringer has been turned off.
2.
If the handset is on the charger cradle (ringer will be temporarily
switched to “Ring” if it has been set to “Vibrate”), lift the handset and
start the conversation.
3. If the handset is not on the cradle, press any key (except END, and the
11
PA paging from
Base 1
SLIENT
11
PA paging
to Ext. # 10
~26~
Silent soft key) to answer.
Notes:
1. You can press SILENT (Left) soft key if you choose to ignore
the call. Unlike turning off the ringer (from the handset menu),
the SILENT key operation is valid only for the current call.
2. If Caller ID service is available, the LCD will display the
incoming call information. If the LCD shows “Private” or
“Unknown”, the caller’s information may have been blocked by
the caller or the originating phone company.
Receiving an Intercom Call
1. When an intercom call arrives, the ringer will ring or vibrate unless the
ringer has been turned off. Press TALK to answer the intercom call.
2.
If the handset is on the charger cradle (ringer will be temporarily
switched to “Ring” if it has been set to “Vibrate”), lift the handset and
start the conversation.
3.
If the handset is not on the cradle, press any key (except END and the
SILENT soft key) to answer.
Notes:
1. The LCD displays the caller’s Handset ID.
2. You can press the SILENT if you choose to ignore the call. Unlike
turning off the ringer the SILENT key operation is valid only for the
current call.
Ending a Call
To end a telephone or intercom call, press END key or place handset into
charging cradle.
Adjusting Receiver (Earpiece) Voice Volume
1. Voice volume can only be adjusted during a call.
2. There are 6 levels of volume selections. Default as
volume 4. Use ¿andÀ scrolling key to adjust.
3. The new setting remains effective for all future calls until changed.
11
00:00:10
Volume:4
OPTION HOLD