Filter
Top Products
5.3.3 Relay Check
The telephone entry system can be called and a check can be made to determine if any of the relays
in the system are in a "hold open" mode. This check can be useful if yourr gate (or door) is held open
and you suspect that the telephone entry system relay may be the cause.
1. Call the telephone number that the entry system is installed on. The system will answer
with a short tone (beep).
2. Press *16 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. The system will emit a series of short tones if the relay is in a continuous activation mode.
Relay 1 activated: beep - pause - beep - pause . . .
Relay 2 activated: beep beep - pause - beep beep - pause . . .
Relay 0 activated: beep beep beep - pause - beep beep beep - pause . . .
4. Press the programmed tone number _ to deactivate the relay (beep). The system will
automatically hang up.
5.3.4 Time and Date Check
This operating functions lets you check the current date, time and day of the week that the system is
currently programmed to. If the calendar chip in the system is not programmed, the system will emit
a long beeeeeep when this function is entered on the key pad. NOTE: The calendar chip can only
be set by the PC when communication is established either by modem or the RS-232 terminals.
1. Press *30 and enter the four-digit MASTER CODE _ _ _ _ (beep).
The display will show: The date - Month / Day / Year
The time - Hours / Minutes / AM or PM (AM=0, PM=1)
The day of the week (1=Sunday, 7=Saturday).
This information will be displayed for approximately four-seconds, then the display
will return to normal.
56