Filter
Top Products
3.3.5 Touch-tone / Rotary-dial
This programming sequence will set the telephone entry system to dial out in either a touch-tone or
rotary format. Generally, this will be set for touch-tone.
Factory setting = touch-tone.
1. Press *07 and enter the four digit MASTER CODE _ _ _ _ (beep).
2. Enter 0* (beep) for touch-tone or enter 1* (beep) for rotary.
3. Press 0# TOGETHER to end this programming step (beeeeeep).
3.3.6 Rotary-dial 9
This programming sequence sets which relay(s) will activate when the system receives a rotary-dial 9
open command from a residents rotary telephone. The system can be programmed so that only one
relay will activate, or any combination of relays will activate. HINT: The relay that you designate as
the primary relay should be programmed to activate from a rotary 9 command. To cause a relay to
activate, enter a 1 in it's respective character slot, or enter a 0 to not activate the relay. Any
combination of 1's or 0's is permissible. For example, entering 010 in step 3 will cause only relay 0 to
activate. Entering 101 will cause both relay 0 and relay 2 to activate.
Factory setting = 010.
1. Press *51 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the three-digit (1's or 0's only) rotary 9 code _ _ _ then press * (beep).
3. Press 0# TOGETHER to end this programming step (beeeeeep).
36