Filter
Top Products
5.3 SYSTEM ADMINISTRATOR
The administrator can perform the following operations from a remote location using a touch tone
telephone. You must know the phone number of the system and the system master code.
5.3.1 Opening from a Remote Location
1. Call the telephone number that the entry system is installed on. The system will answer
with a short tone (beep).
2. Press *16 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Press the desired tone open number _ (beep). NOTE: Refer to 3.3.3 to determine which
tone open features have been programmed, i.e. momentary open, hold open, release,
hold open one hour and then release.
4. Hang up.
5.3.2 Tracker Board Override Hold Open Command
The Tracker board override command is used when tracker expansion boards are connected to the
system. This command will cause ALL tracker boards connected to the telephone entry
system to open or unlock the gate or door that they are controlling, and will remain in this
state until commanded to return to normal operation. This feature is useful when management
wants to open all gates or unlock all doors - perhaps during an emergency situation as an example.
NOTE: Hold open tone numbers must be programmed for the override command to be
functional. See Section 3.3.3.
1. Call the telephone number that the entry system is installed on. The system will answer
with a short tone (beep).
2. Press *16 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Press the hold open tone number that was programmed in section 3.3.3 _ (beep).
4. Hang up.
5. To release the override hold command and return the system to normal operation, repeat
steps 1 through 4. In step 3, enter the DEACTIVATE tone number in place of the HOLD
tone number.
55