Filter
Top Products
3.3 GENERAL PROGRAMMING
Proceed with the programming steps on the following pages only if PC programming will not be used.
3.3.1 Relay Strike Time
These steps will program Relay 0, Relay 1 and Relay 2 strike times. Strike times can be programmed
from 1/4 second (enter 00 in step 4) up to 99 seconds by entering the desired time in seconds. If
Tracker expansion boards are going to be used with this system, set Relay 2 strike time to 00 for
Tracker boards 1-8. If more than 8 Tracker boards are being used, set Relay 1 strike time to 00 (for
Tracker boards 9-16) and then set Relay 0 strike time for the desired time in seconds. In this
application, Relay 0 becomes the PRIMARY relay that will open the door or gate after the tenant
presses 9 on their telephone.
Factory setting for relay strike times are: Relay 0 = 99, Relay 1 = 01, Relay 2 = 01.
1. Press *03 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Press 0* to set relay 0, or 1* to set relay 1, or 2* to set relay 2 strike time.
3. Enter the two-digit strike time _ _ (00-99) then press * (beep).
4. Repeat steps 2 and 3 to set other relay strike times.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
3.3.2 Talk Time
This programming sequence sets the maximum time allowed for conversation when the entry system
places a call to the resident. The talk time can be set from 1 second up to 255 seconds (4 minutes,
15 seconds) and is entered as a three-digit number. For example, to set a talk time of 20 seconds,
enter 020 in step 3. The talk time set here does not affect the telephone numbers that are
programmed under directory codes 0, 00, 000, 0000 and 1, 01, 001, 0001. The talk time for these
two directory codes are factory set to the maximum. Phone numbers programmed under these
directory codes should be reserved for management or emergency phone numbers that generally
require longer conversations.
Factory setting for talk time = 60 seconds.
1. Press *08 and enter the four digit MASTER CODE _ _ _ _ (beep).
2. Enter three digits for talk time (seconds) _ _ _ (001-255) then press * (beep).
3. Press 0# TOGETHER to end this programming step (beeeeeep).
34