Filter
Top Products
42-5
Cisco CallManager Administration Guide
78-13310-01
Chapter 42 Cisco IP Phone Configuration
Configuring Cisco IP Phones
Once you add a Cisco IP phone to Cisco CallManager Administration,
information from the RIS Data Collector service displays on the Phone
Configuration pane. When available, the IP address of the device and the name of
the Cisco CallManager with which the device registered display as illustrated in
Figure 42-1.
Figure 42-1 Phone Configuration Pane
Step 7
Reset the phone after making changes to apply the new settings. Refer to the
“Resetting a Phone” section on page 42-7.
Next Steps
If you want to configure speed-dial buttons to this phone, see the “Configuring
Speed Dial Buttons” section on page 42-20. If you want to configure services for
this phone, see the “Configuring Cisco IP Phone Services” section on page 42-22.
Related Topics
• Cisco IP Phone Configuration, page 42-1
• Resetting a Phone, page 42-7
• Adding a Directory Number, page 42-28
• Deleting a Phone, page 42-10
• Updating a Phone, page 42-9
• Phone Configuration Settings, page 42-12
• Configuring Speed Dial Buttons, page 42-20