Filter
Top Products
Configuration of SIP video endpoints on Communication Manager 6.0
AVTS R 6.0 Quick Setup For feedback, use document@avaya.com August 2010
5
● Perform a network readiness test or network assessment to ensure your network is
capable of supporting bandwidth demands of video over IP. Avaya recommends
implementing quality of service (QoS) across your network
Configuration of SIP video endpoints on Communication
Manager 6.0
This section provides the procedure to configure video calling facility on SIP endpoints with
Communication Manager 6.0.
Enabling video on Communication Manager
The following steps describe administration on both interfaces, SAT and System Manager. Only
the fields that require change are mentioned, the rest may be left as default.
Table 1: Enabling video on Communication Manager
1
Enabling Multimedia IP SIP Trunking feature on Communication Manager
System Management Interface
1. Log in to the Communication Manager System Management Interface.
2. Click Licensing > Administration and navigate to the Feature
Administration page.
3. Verify that the Multimedia IP SIP Trunking feature is set to yes.
2 Enabling Multimedia IP SIP Trunking feature
1. On the System Manager interface, click Elements > Feature Management >
Parameters > System Parameters - Customer Options.
2. Click the arrow icon next to the Select Device(s) from Communication
Manager List.
3. Select the appropriate Communication Manager, and click Show List.
4. Select the radio button in the first column and click View.
5. Click Next Page and ensure the feature Multimedia IP SIP Trunking is set to
y.
Alternatively:
● On the Communication Manager SAT screen, enter display system-
parameters customer-options and ensure the feature Multimedia IP SIP
Trunking is set to y.