Filter
Top Products
Configure H.323 video endpoints on Communication Manager 6.0
AVTS R 6.0 Quick Setup For feedback, use document@avaya.com August 2010
24
4
Use the add signaling-group command to add a signaling group for the
gatekeeper. Set the following parameters:
● Group Type: H.323
● IP video: y
● Priority video. If you want all incoming calls to receive priority video
transmissions, select y
● Near-end Listen Port: 1719
● LRQ Required: y
● Far-end Node Name to the name you entered for the gatekeeper in Step 3.
● Far-end Listen Port: 1719
● Far-end Network Region to the IP network region you specified in Step 2.
● Direct IP-IP Audio Connections: y
● IP Audio Hairpinning: y
5
Use the add trunk-group command to add a trunk group for the gatekeeper. Set the
following parameters:
● Group Type: ISDN
● Carrier Medium: IP
● Add members to this trunk group
6
Use the change signaling-group n command (where n is the signaling group
you added in Step 4) to set Trunk Group for Channel Selection to the trunk group you
added in Step 5.
7
Create a route pattern to the gatekeeper.
8
Configure the gatekeeper.
Table 11: Administering Polycom PathNavigator/ CMA Gatekeepers