Filter
Top Products
Configure H.323 video endpoints on Communication Manager 6.0
AVTS R 6.0 Quick Setup For feedback, use document@avaya.com August 2010
17
Configuring Polycom RMX Series Video Conferencing Bridge
Platform
Use this procedure to configure the Polycom RMX series video conferencing Bridge platform.
Table 8: Configuring Polycom RMX Series Video conferencing on Bridge Platform
1. Enter change node-names ip to add an entry for the RMX system. Be sure to enter
the IP address of the IP board for the RMX system.
2Enter add trunk-group to add a two-way trunk group for the RMX system. Set the
following parameters:
● Group Type: ISDN
● Direction: Two-way
● Carrier Medium: H.323
● Service Type: Tie
3Enter add signaling-group to add a signaling group for the RMX system. Set the
following parameters:
● Group Type: H.323
● IP Video: y
● Priority Video. If you want all incoming calls to receive priority video
transmissions: y
● Trunk Group for Channel Selection to the two-way trunk group you added.
● Near-end Node Name. PROCR may be used for all systems and CLAN may be
used for systems with port networks.
● Near-end Listen Port: 1720
● LRQ Required: n
● RRQ Required: y
● Enable Layer 3 Test: n
● Far-end Node Name to the name you entered for the RMX system
● Far-end Listen Port: 1720
● Far-end Network Region
● Calls Share IP Signaling Connection: n
● Direct IP-IP Audio Connections: y
● IP Audio Hairpinning: n