Filter
Top Products
...,-.,"'
u'r:a"tions
.~,;~~~~~(
c1:"",,,-,.:':.i
This equipment complies with Parts 15
and 68 of the Federal Communications
Commission (FCC) rules for the United
States. It also complies with regula-
tions RSS21O and CS-O3 of Industry
and Science Canada. Operation is
subject to the following two conditions:
( 1) this device may not cause interjer-
ence, and (2) this device must accept
any interference. including interfer-
ence that may cause undesired opera-
tion of the device.
FCC Part 15
Warning: Changes or modifications to
this unit not expressly approved by the
party responsible for compliances could
void the user's authority to operate the
equipment.
The equipment has bee"n tested and
found to comply with part 15 of the FCC
rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment gener-
ates, uses and can radiate radio
frequency energy and, it ~ot installed
and used in accordance with the
instructions, may cause harmful inter-
terence to radio communications.
However, there is no guarantee that
interference will not occur in a particu-
lar installation. If this equipment does
cause harmful interference to radio or
television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try and correct the interference by one
or more of the following measures:
A label is located on the underside of
the base unit contairing either the FCC
registration number and Ringer
Equivalence Number (REN) or the
Industry Canada (IC) registration
number and Load Number. You must,
upon request, provide this information
to your local telephone company.
-@-
I
-@-
This equipment is compatible with
inductively coupled hearing aids.
Should you experience trouble with
this telephone equipment, please
contact:
AUDIOVOX COMMUNICATIONS
SERVICE DEPT. at (800) 229-1235.
For repair/warranty information. The
telephone company may ask you to
disconnect this equipment from the
line network until the problem has been
corrected.
Reorient or relocate the receiving
antenna.
Increase the separation between-
the equipment and receiver.
Connect the equipment into an
outlet or on a circuit different from
that to which the receiver is con-
nected.
Consult the dealer or an experi-
enced radio/TV technician for help.
4
~
II
OT94102.p65
4
6/24/98. 12:19 PM
-~-