Filter
Top Products
7
Getting started
7
Battery installation & charging
Place the battery
and wires in the
compartment.
Low battery indicator.
Off hook mode.
Caution: Use only the supplied rechargeable
battery or AT&T replacement battery model 3301
(SKU 91076, part number 80-5071-00-00).
Press in and downward
on the tab to open the
battery compartment
cover.
Slide the battery com-
partment cover up until
it clicks into place.
Place the cordless hand-
set in the telephone base
or charger to charge for
at least 16 hours before
first use.
Plug charger power adapter
into the jack on the under-
side of the charger, then plug
the adapter into an electrical
outlet not controlled by a wall
switch.
BATTERY LOW
--1--
8/12 10:06
am
Plug the battery connector
into the handset battery
compartment, matching the
color coded label.
After battery installation, place the cordless handset in the telephone base or charger
and allow to charge for at least 16 hours before use. You can keep the battery charged
by returning the cordless handset to the telephone base or charger after each use. When
the battery is fully depleted, a recharge takes about 16 hours. The talk time on a fully
charged battery is about five hours depending on environmental conditions, and the standby
time is approximately five days. Actual battery life will depend on the usage conditions, and
the age of the battery.
Return cordless handset to the tele-
phone base or charger to recharge
when this symbol appears.
(When in use the cordless handset
will beep when battery is low).
Low battery indicator.
Idle mode.
3
--1--
8/12 10:06
am