Filter
Top Products
Getting Started
7
Additional storage
MyPal A626/A686/A696 comes with the standard SD card slot. The SD
card slot can be inserted with SD or MMC memory cards. It also supports
SDIO cards of various functionalities including 802.11b/g, modem, etc.
Label
Installing and removing SD/
MMC/SDIO card
1. With the label side (usually the side with the
card manufacturer’s name) face up, and the
barcode/serial number side face down, insert
the card into the SD card slot located on top
of the device.
2. Push the card all the way into the slot until it
ts completely. If properly installed, the SD
or MMC card edge aligns with the top edge
of the device. SDIO cards usually have an
extended part that protrudes over the slot
edge.
3. To remove, press the card slightly until it
ejects out. You may then safely remove the
card.
NOTE An SD/MMC/SDIO/ card ts only in one
orientation, and slides smoothly into the
slot if inserted correctly. DO NOT force
the card into the slot!
NOTE Remove the car holder and take the device with you
when you leave the car.
Gently bend the gooseneck when adjusting the
orientation. Do not forcibly bend the gooseneck. The
device must be carefully placed into the holder to avoid
damaging the mini USB connector and causing the device
to breakdown.