Filter
Top Products
TA 850 User Manual © 2001, ADTRAN, Inc.
61200375L1-1
TA 850
T1 RCU VoATM UIG/61200376L2-31A
Page 50 of 72
The following settings are used for FRF5.
L
AN
FR M
AINT
P
ROTOCOL
Frame Relay maintenance or signaling protocol
between local V.35 port and the attached DTE
port, support ANSI Annex A, CCITT Q933 An-
nex D, CISCO LMI or Static (no signaling).
L
AN
FR P
OLL
T
IMEOUT
T392 (5-30)
T392for signaling protocol,typicalvalue 15.No
meaning if Maint Protocol is Static.
FRN P
ORT
C
ONFIG
Logical Frame Relay ports over ATM. Up to 4
ports are supported with each port supporting up
to 4DLCI mappings.Go to
NUM
field.Typing "i"
or "I" will insert another entry,and typing "d" or
"D" will delete one entry.
N
AME
To identify your port.
ATM VPI
Specifies the virtual path over which this
logical port is running.
ATM VCI
Specifies the virtual circuit over which this
logical port is running.
D
E
M
AP
Frame Relay to ATM demapping; default
value (Frn Only, ATM 0) suggested.
CLPI M
AP
ATM to Frame Relay CLPI map; default
value (Frn Only) suggested.
D/C
Set D/C field in the header to 0 or 1.
H
EADER
Header format; only 2 bytes supportednow.
M
AINT
P
ROTOCOL
Maintenance or signaling protocol over this
logical Frame Relay port. Support Annex A,
AnnexD,CISCOLMIorStatic.
M
UX
M
ODE
Many DLCIs orone DLCI mapping overthis
port.
DLCI M
AP
Actual DLCI mappings.
L
AN
DLCI
The DLCI configured over local V.35
Frame Relay port.
N
ET
DLCI
The DLCI configured over the WAN
side logical Frame Relay port.
A
CTIVE
Always active, not configurable.