Filter
Top Products
Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 181
.
2. Configuring the Layer 2 Protocol
For more details on the configuration parameters discussed in this section, refer to the following pages:
Layer 2 ATM Network Interface Protocol menus beginning on page 101
Ethernet Interface Setup Instructions
Most applications should not require a manual setup for the Ethernet interface. By
default, the Ethernet interface is configured to auto-detect the data rate (as either 10
or 100 Mbps). The following steps disable the auto-negotiation parameter and
manually configure the interface.
Step Action
1
From the main menu, select I
NTERFACES
.
2
Highlight the C
ONFIG
menu for the ETH interface and press <E
NTER
>.
3
Use the right arrow to select A
UTONEGOTIATION
and press <E
NTER
>. Use the
down arrow to choose OFF.
4
Select the D
ATA
R
ATE
field and specify either 10B
ASE
T or 100B
ASE
T.
5
Select the D
UPLEX
T
YPE
field and specify either H
ALF
D
UPLEX
or F
ULL
D
UPLEX
.
Layer 2 Protocol (ATM) Configuration – T1 Interface
Step Action
1
From the main menu, select L2 P
ROTOCOL
and press <E
NTER
>.
2
Use the arrow keys to select the P
ROTOCOL
field for the T1 interface. Press
<E
NTER
>. Select ATM from the list of available protocols.
3
Use the arrow keys to select the C
ONFIG
menu for the T1 interface and press
<E
NTER
>.
4
Highlight the ATM C
ONFIG
menu for the T1 interface and press <E
NTER
>.
5
Enter the I
DLE
C
ELLS
format for your network.
6
Set D
ATA
S
CRAMBLING
appropriately for your network.
7
Back all the way out to one level to the PVC C
ONFIG
menu, and press <E
NTER
>.
Enter the VPI and VCI values for communicating with that Gateway. Select
R
OUTER
under the C
ONNECTION
field.
8
Select the S
ETUP
menu and configure the virtual circuit for IP or PPP operation.
(Our example selects IP.) Refer to
L2 Protocol (ATM–NET–ATM) > Config >
PVC Config > Setup (Router) on page 103
for more details.