Filter
Top Products
Section 4 User Interface Guide Total Access 600 Series System Manual
144 © 2004 ADTRAN, Inc. 61200624L1-1B
N
AME
Identifies the filter entry. Default is no entry in name field.
F
ILTER
T
YPE
Specifies a
N
ORMAL
or
D
EBUG
filter. When a
N
ORMAL
filer is applied to an interface, traffic is blocked
or forwarded according to the filter. When a
D
EBUG
filter is applied, packets that match the filter are
documented without affecting traffic flow. (Use the
D
EBUG
filter with the Syslog or Terminal Mode
logging to view the packet contents.)
S
RC
A
DDR
IP address compared to the source address. Value is in dotted decimal format. Default is
0.0.0.0
.
S
RC
M
ASK
Bits which are used in the source comparison. Value is in dotted decimal format. Default is 0.0.0.0.
D
EST
A
DDR
IP address compared to the destination address. Value is in dotted decimal format. Default is 0.0.0.0.
D
EST
M
ASK
Bits which are used in the destination comparison. Value is in dotted decimal format. Default is
0.0.0.0.
S
RC
P
ORT
IP source port number used for comparison. Value is in decimal format. Range: 0 - 65535. Default is
0.
S
RC
P
ORT
C
OMP
Type of comparison that is performed. Default is N
ONE
.
= means ports equal to
NOT
= means port not equal to
> means port greater than
< means port less than
None - means the source port is not compared
D
EST
P
ORT
IP destination port number used for comparison. Value is in decimal format. Range: 0 - 65535.
Default is
0.