Filter
Top Products
Section 4 User Interface Guide Total Access 600 Series System Manual
170 © 2004 ADTRAN, Inc. 61200624L1-1B
The following example provides step by step instructions for configuring the Total Access 6XX T1 ATM
system (
I
NTERFACES
and L2 P
ROTOCOL
) for a standard voice application. System Info and System Config
parameters should be set according to your system need. Refer to System Info on page 49 and System
Config on page 51 for more details.
1. Setting up the Interfaces
For more details on the configuration parameters discussed in this section, refer to the following pages:
Network T1 menus beginning on page 71
FXS menus beginning on page 82
T1 Interface Setup Instructions
Step Action
1
From the main menu, select I
NTERFACES
.
2
Highlight the C
ONFIG
menu for the T1 interface and press <E
NTER
>.
3
Right arrow to select F
ORMAT
and choose ESF or SF.
This format must match the format used by the other units in the
network.
4
Set the L
INE
C
ODE
to B8ZS or AMI.
This line code must match the line code used by the other units in the
network.
5
Set the E
QUALIZATION
or line build out. The default setting of 0
D
B is
usually sufficient.
6
Set the CSU L
PBK
option to E
NABLE
, D
ISABLE
, or D
ISABLE
A
LL
based on
whether looping to this unit from another unit will be allowed.