Filter
Top Products
Section 4 User Interface Guide Total Access 600 Series System Manual
172 © 2004 ADTRAN, Inc. 61200624L1-1B
2. Configuring the Layer 2 Protocol
For more details on the configuration parameters discussed in this section, refer to the following pages:
Layer 2 ATM Network T1 menus beginning on page 101
11
Press <E
NTER
> on the T
ANDEM
[+] option to view the T
ANDEM
options if
the port mode is set to T
ANDEM
(E&M).
12
Set the C
ONVERSION
M
ODE
of the port to either L
OOP
S
TART
or G
ROUND
S
TART
.
13
Set the S
UPERVISION
of the port to either I
MMEDIATE
or W
INK
.
Be sure to set the T
ANDEM
options for each port set to T
ANDEM
E&M.
Layer 2 Protocol Configuration – T1 Interface
Step Action
1
From the main menu, select L2 P
ROTOCOL
and press <E
NTER
>.
2
Use the arrow keys to select the P
ROTOCOL
field for the T1 interface. Press
<E
NTER
>. Select ATM from the list of available protocols.
3
Use the arrow keys to select the C
ONFIG
menu for the T1 interface and press
<E
NTER
>.
4
Highlight the ATM C
ONFIG
menu for the T1 interface and press <E
NTER
>.
5
Enter the I
DLE
C
ELLS
format for your network.
6
Set D
ATA
S
CRAMBLING
appropriately for your network.
7
Back all the way out to one level to the PVC C
ONFIG
menu, and press <E
NTER
>.
Enter the VPI and VCI values for communicating with that Gateway. (From this
menu, the appropriate Voice information for working with the Voice Gateway is
entered by selecting V
OICE
under the C
ONNECTION
field.)
FXS Interface Setup Instructions (Continued)