Filter
Top Products
Your telephone set has been prepared at the factory for use on your desk. If
you require the set to be positioned on a wall, follow procedure.
To mount the M6320 on the wall:
1. Pull off the wedge-shaped base unit (stand) from the telephone set.
2. If the set is to be connected to a line cord connecting block mounted
on the wall, push out the knock-out section in the base (F) as shown in
Figure 1.
3. Reposition the stand on to the base the other way round. Press the
stand firmly into the bottom of the set until the plastic tabs have
clicked into place.
4. Insert the two screws into the screw mounts shown in Figure 1.
Tighten the screws until the stand is seated securely. Do not over tight-
en the screws as this may cause the plastic to crack.
Wall mounting the M6320
44
Figure 1 - M6320 wall mounting positions