Filter
Top Products
E-23
English
Inserting batteries into the
remote control
The CR102 universal remote
controller
e CR102 is a sophisticated ‘universal’ backlit remote
control that can control up to eight devices. It is pre-
programmed for use with the AVR360 and many other
Arcam products (FM/DAB tuners, CD players and DVD
players).
With its extensive built-in library of codes, it can also
be used with thousands of third party audio-visual
components – TVs, satellite and set-top boxes, PVRs,
CD players, etc. See the list of codes at the back of this
handbook, beginning on page 56.
e CR102 is a ‘learning’ remote, so you can teach it
almost any function from an old single-device remote.
You can also program the CR102 to issue a sequence of
commands (‘macros’) from a single button press.
remote
control
Using the remote control
Please keep in mind the following when using the
remote control:
< Ensure there are no obstacles between the
remote control and the remote sensor on the
AVR360. e remote has a range of about 7
metres. (If the remote sensor is obscured, the Z1
IR remote control input jack on the rear panel is
available. Please consult your dealer for further
information.)
< Remote operation may become unreliable if
strong sunlight or uorescent light is shining on
the remote sensor of the AVR360.
< Replace the batteries when you notice a
reduction in the operating range of the remote
control.
Notes on batteries:
<
Incorrect use of batteries can result in hazards such
as leakage and bursting.
<
Do not mix old and new batteries together.
<
Do not use non-identical batteries together –
although they may look similar, dierent batteries
may have dierent voltages.
<
Ensure the plus (+) and minus (-) ends of each
battery match the indications in the battery
compartment.
<
Remove batteries from equipment that is not going
to be used for a month or more.
<
When disposing of used batteries, please comply
with governmental or local regulations that apply in
your country or area.
4
32
1
8
7
6
5
0
9
MCH
TAPE
SHIFT
iPOD
RPT
NET
TV
AV
RND
PHONO
AUX
DVD
SAT AV
TUN
AMP
PVR VCR
CD
OK
CR102
MODE
DISP
MENU
EFFECTDIRECT EQ BASS
SUBTRIM SYNC TREBLE
INFOHOMEFAVÐFAV+
SRCH
SUBTAUDIOTITLESETUP
CH
1. Open the battery compartment by pressing the
button on the back of the handset.
2. Insert four ‘AAA’ batteries into the battery
compartment – two facing the top of the unit,
and two facing the end, as in the diagram.
3. Lower the end cap onto the plastic locating plate
in the handset. is acts as a hinge, and you
can now push the end cap rmly into its locked
position with a click.