Yamaha PJP-100H Conference Phone User Manual


 
29
Setting Menu List
CONFIGURATIONS
English
To specify the area to which this feature is available, use
the numeric keys in “Microphone Mode” menu.
According to the pressed keys, audio in the area of the
following figure is picked up or not.
Microphone indicators (blue LED) of which direction
audio can be picked up from light up. This mode indicated
by on the display.
y
Press to pick up audio from all directions.
You can select multiple areas at the same time.
You can select areas to where the audio pickup feature is not
applied.
Using the keys on this unit
In the initial display, select “Menu” “Settings”
“Sound Settings” “Microphone Mode”.
y
You can display “Microphone Mode” menu by pressing
continuously in the initial display or calling display.
Using the web menu
In the web menu, select “Microphone Mode”.
Configuring the speaker mode
You can select the mode of audio output from the speakers
during call. The default setting is “Divide”.
Divide: When this unit communicates with multiple
locations, the audio from other units is divided
according to their locations. This mode is indicated by
on the display.
The position from which the audio from each location
is assigned automatically according to the number of
connected locations, that is, to the left/center/right
positions in a conference call with 3 locations, to the
left/center positions in a conference call with 2
locations and only to the center position in a call with a
single location.
Monaural: Even during call with more than one
location, the audio from other units is not divided
according to their locations. This mode is indicated by
on the display.
Small Area: The area from which the audio from other
units is limited as shown below (monaural output).
This mode is indicated by on the display.
Medium Area: The area from which the audio from
other units is limited as shown below (monaural
output). This mode is indicated by on the display.
Large Area: The area from which the audio from other
units is limited as shown below (monaural output).
This mode is indicated by on the display.
When “Connection Mode” (page 27) is set to “Cascade Server”
or “Cascade Client”, the audio is always output in the monaural
speaker mode even when “Divide” is selected.
When “Speaker Mode” is set to “Divide”, the speaker output
positions depend on an connected order. To change the speaker
output positions according to locations, see “Changing the
speaker output positions according to locations” (page 23).
123
456
789
0
MUTE
LAN
VOL
DC IN 12VIN AUDIO OUT
1 2 3
7
8
9
Within 2 m
Within 2 m
5
123
456
78
9
0
MIC MUTE
LAN
VOL
DC IN 12VIN AUDIO OUT
Notes
123
456
78
9
0
MUTE
LAN
VOL
DC IN 12VIN AUDIO OUT
123
456
78
9
0
MUTE
LAN
VOL
DC IN 12VIN AUDIO OUT
123
456
78
9
0
MUTE
LAN
VOL
DC IN 12VIN AUDIO OUT
01EN_00_PJP-100H_UCGB.book Page 29 Wednesday, August 23, 2006 3:04 PM