Filter
Top Products
Preparation Procedure
11
PREPARATION
English
■ Assigning the IP address manually
Follow the procedure below to register the network
information manually.
Before setting the network information, check that this unit is
connected properly to the network. If the disconnected icon
(page 10) is displayed on the top right of the display, check the
LAN cable connection and the condition of the network to which
the LAN cable is connected.
y
The factory settings of the network information are as follows.
– IP address: 192.168.100.200
– Subnet mask: 255.255.255.0
– Default gateway: 0.0.0.0
1 Press repeatedly until the initial display
appears.
“???.???.???.???” is displayed when the DHCP server
does not exist in the network, and the IP address
obtained from the DHCP server is displayed when it
exists.
2 Press .
The menu screen appears.
3 Press or to select “1. Settings”, and
then press .
The “Settings” menu appears.
4 Press or to select “1. Network Settings”,
and then press .
The “Network Settings” menu appears.
Note
123
456
78
9
0
MIC MUTE
LAN
VOL
DC IN 12V IN AUDIO OUT
/ /
Numeric keys
Menu :Address
IP: ???.???.???.???
3. Online
2. Call History
1. Settings
Menu
3. General Settings
2. Sound Settings
1. Network Settings
Settings
3. Default Gateway
2. Subnet Mask
1. IP Address
Network Settings
01EN_00_PJP-100H_UCGB.book Page 11 Wednesday, August 23, 2006 3:04 PM