Filter
Top Products
General Purpose Control
Tie-line
Station may be restricted from access to this function. This
function can control other equipments by employing the
Data Transmitting and Receiving Units.
Select the required type of output.
(Mode 1) One-shot make output (500/50 contacts)
Dial
and the relay output is made for 1 to 2 seconds.
Example: Door remote and VTR control
Note: Operation performed even when all link circuits
are occupied.
(Mode 2) Make/break output (512/100 contacts)
Dial
and the make output is sent out.
Dial
and the break output sent out.
Example: In/out annunciation, Prescription annunciation.
(Mode 3) 8-selectable one-shot make output (9 units)
Dial
and one contact out of 8 selectable make outputs is
obtained for about 1 or 2 seconds.
Example: VTR control
(Mode 4) 8 selectable make output and/or decimal output
(A) 8 selectable make output (64/9 units)
Dial
and one of the 8 relay outputs is made. "Clear" opera
tion makes all 8 relays break.
Example: Destination indication, room condition
indication, ITV control
(B) Decimal output
Dial
and the condition is indicated numerically.
Example: Destination indication, room condition
(Mode 5) 4 decimal digits output
Dial
and 4 decimal digits are indicated.
Example: Prescription annunciation
Fig. 1 Control with one-shot make output
Door
remote
control
Fig. 2 Lamp on/off indication panel
Fig. 3 VTR control with 8-selectable one-shot make output
Fig. 4 8 selectable output type indication panel
Fig. 5 Decimal output type indication panel
Fig. 6 4 decimal digits type indication panel
Unit No. Contact No.
Condition No.
Unit No.
Condition No.
Unit No.
4 decimal digits
Unit No.
– 95 –