Filter
Top Products
Pocket Pager
The system can be connected with usual type Pocket pager
using the interface with Make/break relay output.
1. Dial
(00 ~ 99, Pager No.)
and the pager is called after confirmation tone is heard.
2. When
(00 ~ 99, Pager No.)
is dialed by the party called from the nearest master
station, it is possible to respond a call to the station.
Note.
1. Once a receiver is called from one station and a
response is waited for, camp-on-busy will result for
other callers. But, if a response to the call is not
received within 3 minutes, the terminal can be called
from a new calling station.
2. If the pager is called after confirmation tone is heard,
a calling station is disconnected from the speech line
and waits for a response while the relay for pager
transmission is kept in the Make position till a
response is made. The station which waits for a
response can be called from the other stations.
3. The other stations can call the other pagers while one
station makes a call and is waiting for a response.
4. Dialing (pager number that is called)
cancells calling the pager if the wrong number has
been pressed.
5. When the exchanges are connected by tie-lines, it is
only possible to call the pager from the stations con-
nected to the exchange "A" for stations No. 200
through 455. A pager response can be made from any
station.
Response call
Pager receiving call
Response
(From the nearest station)
Pager call
Pager transmitter
– 57 –