Filter
Top Products
Master Sub Relationship
Master/Substation associations are set up by using station
#200 as the programming station. Once these relationships
have been established, substations can then contact their
designated master stations by simply touch dialing
If TL-600S Handset substation is used, substations can be
connected to their designated master stations by simply
picking up a handset. (Only applicable to
system)
With respect to this function, the stations in the system are
divided into two categories; master stations and substations.
Any master station can be connected to any other station
in the system. However, substations can initiate calls only
to specific master stations. This is done by single touch
dialing, and will only connect the substation to one specific
master.
Several substations can be programmed under this station
to connect with a single specified master station.
To register single digit dialing, touch dial
substation number
Single digit dialing from that master to a specific substation
is then accomplished by touch dialing
Programming a master station for Single Digit Dialing of a
substation number under this function is programmed in
the same manner as other single digit dialing, and results in
one touch dialing from master to substation.
Note.
Single digit registration is not available from any substa-
tion programmed by No.200 programming, even if its
line is connected with master station.
Automatic Access To Paging
Substation
Master Station
Handset substation
Only applicable to
system
Single Digit Registration of Substation
Once programming has been set up for the purpose of this
function.
Paging call
A paging call may be made from specific Handset Sub-
stations to the registered zone by simply picking up a
handset. Refer to Fig. 1
A specific Handset substations may respond to the paging
call by simply picking up a handset. Refer to Fig. 2
Fig. 1
Note.
Paging call
Single digit registration for Handset Substation as well
as No.200 programming is required for this function at
the time of installation.
Paging response
Response to
a paging call
Fig. 2
Master Station
Substation Number
Substation
NP Type
– 27 –