Filter
Top Products
2) Press to select CIDW
or CIDCW
3) Press the soft key on the base).
You will hear a confirmation tone.
/volume up/down
On Off.
OK
Setting the Dial Mode (Australia Only)
menu/del MENU
OK
Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone
dialing; the default setting is tone dialing. Set the dialing mode to match the dialing
system used by your local phone service.
If you are not sure of your dialing system, make a trial call. If the call connects,
leave the setting as is; otherwise set the unit to pulse dialing.
If your phone system requires pulse dialing and you need to send DTMF tones
in certain situations during a call, you may switch over to tone dialing (refer to
"Tone Dialing Switch-over" on page 36).
1) Press (or the soft key
on the base). Select the Global Setup menu,
and then the Dial Mode submenu.
2) Press to select or
(the initial setting is Tone).
3) Press (or the soft key on the
base). You will hear a confirmation tone.
!
!
/volume up/down
select/
Tone
Pulse
GETTING STARTED
Dial Mode
Tone
Pulse
[26]
CIDCW
CWDX On
CWDX Off