Filter
Top Products
54
Resetting the Voice Mail Waiting Light
If the voice message waiting light continues blinking even after you've retrieved your messages, press and hold FIND
HS
key until the light stops blinking.
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base. Your unit comes with a
preset security code. Resetting this code is not normally necessary. In the rare situation that you suspect another
cordless telephone is using the same security code or if you are instructed to change this code by a Call Center
Representative, reset the handset to change the code (see
Resetting the Handset on page 53).
Traveling Out of Range
During a call, if you move your handset too far from your base, noise may increase. If you pass the range limit of the
base, the handset will beep, display OUT OF RANGE, and then go to standby. The base will maintain the connection
for 30 seconds after the handset goes out of range. If you move the handset back within range of the base within 30
seconds, press TALK/FLASH or SPEAKER to pick up the call again.
Common Issues
If your phone is not performing to your expectations, please try these simple steps first. If these steps do not solve
your problem, please call our Customer Hotline (see back cover page).
Symptom Suggestion
The charge LED won't
come on when the handset
is placed in the base.
• Make sure the AC adapter is plugged into the base and wall outlet.
• Make sure the handset is properly seated in the base.
• Make sure the charging contacts on the handset are clean.
The audio sounds weak.
• Move the handset and base away from metal objects or appliances.
• Make sure that you are not too far from the base.