Filter
Top Products
1) When the phone is in the standby
mode, press and hold cid/hold until
the Caller ID setting screen appears.
2) Press
*
/
tt
/tone or # /
s
to select ”Line1” or ”Line2”.
3) Press
▲
/up/intcm or
▼
/down/conf. .
The following screen appears.
4) Press
▲
/up/intcm or
▼
/down/conf. to move the cursor to the
selection that you would like to change. Press the
select/channel key to toggle between ”
On”and ”Off”.
5) After you have made your selections, press cid/hold and
return the handset to the base.
[ 11 ]
GETTING STARTED
GETTING STARTED [ 11]
Setting Caller ID Options
There are three Caller ID setup options available; they are AutoTalk, CIDCW (Caller
ID on Call Waiting), and Area Code. See page 12 for Area Code setup instructions.
AutoTalk allows you to answer the phone without pressing line 1.
If the phone rings when AutoTalk is on, simply remove the handset from the base
and the phone automatically answers the call. Or if the handset is not on the
base, press any key to answer the call. If the phone rings when AutoTalk is off,
you must press line 1 to answer the call.
CCaalllleerr IIDD oonn CCaallll WWaaiittiinngg ((CCIIDDCCWW))
performs the same as regular Caller ID on a call
waiting number.
YYoouu mmuusstt ssuubbssccrriibbee ttoo CCIIDDCCWW ffrroomm yyoouurr pphhoonnee ccoommppaannyy iinn oorrddeerr
ttoo uussee tthhiiss ffeeaattuurree..
To change your Caller ID options:
TRU3466 ENG 8/8/01 12:18 PM Page 11