Uniden EXA2950 Cordless Telephone User Manual


 
[ 15 ]
BASICS
BASICS
Redial
The
rreeddiiaall
key redials the last number dialed. The redialed number can be up to 32
digits long.
The tone feature only
applies when the dial
mode is set to pulse.
Tone Dialing Switch-over
Some telephone companies use equipment that require pulse
dialing (sometimes referred to as rotary dialing). If you need
to enter tone dialing digits, you can switch-over to tone
dialing during the call. An example of this could be entering
your bank account number after you have called your bank. The
digits of your bank account can be sent using DTMF tones.
Initially make your call with the pulse dialing mode. Once your call connects, press
*
//ttoonnee
. Enter the desired number (like in the example above, the bank account
number). These digits will be sent as tone dialing. This special number can be stored
in a memory location. This is referred to as Chain Dialing (See page 19.). Once the
call ends, the tone mode is canceled and pulse dialing mode resumes.
Traveling Out-of-Range
During a call, as you begin to move your handset too far from your base unit, noise
increases. If you pass the range limits of the base unit, your call will terminate
within 30 seconds.