Filter
Top Products
If your telephone outlet isn’t modular,
contact your telephone
company for assistance.
[ 10 ]
GETTING STARTED
DD.. CChhoooossee tthhee ddiiaalliinngg mmooddee
Most phone systems use tone dialing which sends DTMF tones through the phone lines.
However some phone systems still use pulse dialing such as in rural areas. The default
setting is tone dialing. Depending on your dialing system, set the mode as follows:
1)Press and hold
ffllaasshh
until you hear a confirmation tone.
2)To set the dial mode for pulse dialing, press
##
.
Or to set the dial mode for tone dialing, press
*
/
ttoonnee
.
A confirmation tone sounds to indicate the setting is complete.
• If you are not sure of your dialing system, set for tone dialing. Make a trial call.
If the call connects, leave the setting as is, otherwise set for pulse dialing.
• If your phone system requires pulse dialing and you need to send DTMF tones for
certain situations during a call, you may "switch-over" to tone dialing.
(Refer to "Tone Dialing Switch-over" on page 15.)
Modular
Make sure your battery
pack is fully charged
before choosing the
dial mode.
5)Connect the telephone line cord to the
TTEELL LLIINNEE
jack and a telephone outlet once the handset is
fully charged.
After installing the battery pack in the handset, charge your handset at least
1122--1155 hhoouurrss bbeeffoorree pplluuggggiinngg iinnttoo tthhee pphhoonnee lliinnee
. Once the handset battery pack is
fully charged, connect the telephone line cord to the base and telephone wall outlet.