Filter
Top Products
ADDITIONAL
INFORMATION
ADDITIONAL INFORMATION [ 55]
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and
the main base unit. This cordless telephone uses a digital security code to prevent
unauthorized access to your base unit. This security code prevents other cordless
handset from making calls through your base unit. Normally, setting the code is not
necessary.
The first time you charge your handset, the security code is automatically set.
In the rare situation that you suspect another cordless telephone is using the same
security code, you can change the code.
1) Remove the handset from the main base unit. Press and hold find handset on the
main base.
2) The handset begins emitting a paging sound. While holding find handset, place
the handset on the main base unit. The paging sound stops.
Leave the handset on the main base for more than 3 seconds. A new random
security code is set.
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
Headset Installation
Your phone may be used with an optional headset, the Uniden HS910.
To use this feature, insert headset plug into the headset jack.
Your phone is ready for hands-free conversations.
(Headset may be purchased by calling the Uniden Parts Department or
visiting the web site. See Page 7.)
• You can change the
phone’s digital
security code on
either handset.
However, you must
re-register the other
handset (not used to
change the digital
security code) back to
the main base unit.
See registration on
page 12.
• If the handset battery
pack is completely
discharged or the
battery pack is
removed, the digital
security code will be
lost. If this happens,
a new security code is
set automatically next
time the battery pack
is charged in the
main base.
DXAI388-2 7/16/2 11:55 AM Page 55