Filter
Top Products
GETTING STARTED[ 12 ]
• When you charge the
handset, the Caller ID
summary screen and
the name of the
handset, HS1
appears. If HS2
appears, you are
charging the handset
No.2.
• The smaller cradle is
simply an extra
charging device for
either handset.
Before Using, Register Extra Handset to the
Main Base Unit
The handset that is placed on the main base unit first will automatically be
registered to the main base unit. (It does not matter which handset you choose to
place on the main base unit first).
You will also need to register the extra handset by placing it on the main base.
The extra handset WILL NOT operate properly until the registration has been
completed. Once the handset is registered, it is ready for use.
Follow these simple steps to register:
1) First, install the battery packs in both handsets. Place either handset on the
main base, then place the extra handset in the extra charging cradle. Charge
both handsets for 15-20 hours.
2) After fully charging both batteries, remove the handset in the extra charging
cradle, and place it on the main base. The status LED light on the main base will
begin to flash, indicating that the registration is taking place between the extra
handset and the main base.
3) Wait for at least 5 seconds before removing the handset from the main base.
Congratulations, the registration has been completed, and your dual handset
cordless phone is ready for use!
HS1
New :01
Total :02
DXAI388-2 7/16/2 11:54 AM Page 12