Filter
Top Products
GETTING STARTED
GETTING STARTED [ 9]
B. Install the battery packs
Charge the battery packs for at least 15-20 hours
before plugging the phone line into your phone.
1) Press in on the battery cover release and slide the
cover down until it comes off.
2) Connect the battery pack connector observing correct
polarity (black and red wires) to the jack inside the
battery compartment.
Do not exert any force on this connection. It could
cause damage to the battery or to the handset. The
plastic connectors will fit together in only one way.
Once you are certain that you have made a good
connection, then insert the battery pack into the
battery compartment. Do not pinch the wires.
3) Securely close the battery compartment cover by
sliding it up until it snaps into place.
4) Place the handset on the main base and the other in
the extra charging cradle.
• Use only the Uniden
battery (BT-905)
supplied with your
phone. Replacement
batteries are also
available through the
Uniden Parts
Department.
(See page 7.)
• Place the extra
handset in the charger
with the keypad
facing forward for
15-20 hours before
use.
DXAI388-2 7/16/2 11:54 AM Page 9