Filter
Top Products
Jsing Search Delay
)n some two-way channels there might be
;hort lapses in the signal before a reply. The
Search Delayfeature causes the scanner to
Nait two seconds after the end of a
transmission before resuming searching, in
:ase there is a reply.
Unlike Scan Delay, you don't have to turn
on Search Delay for each frequency in the
search range. Search Delay works for the
entire frequency range you chose.
To turn on Search Delay:
Press DLV again, to turn off Search Delay.
Locking Out Frequencies
Note: This feature is similar to locking out a
programmed channel, except you can only
lock out 50 frequencies. You can lock out
any number of channels.
During a search, you might repeatedly
encounter frequencies that you are not
interested in. Also, all scanners are subject
to receiving internally generated frequencies
(called birdies) that stop your scanner's
search when there is no real signal present.
See "UBC3000XL T Birdies" on Page 43.
In either case, you can lock out up to 50
such frequencies to make your scanner
search more efficiently. If you try to lock out
more than 50 channels, the 51st channel
replaces the first channel in memory.
7r
Locking Out a Frequency
When the scanner stops on a frequency you
want to lock out:
Press
11 12 13
(OSCAN] 0 @ @
14 15 18
(OIlAN~ @ @ @
8 § 0/ @18@19
8FT 20
€](30@@
BANK 2
DAft" DLY SRCH.
~?:~888.888 11Hz
& KHI NFII
Searching resumes immediately.
30
---
(OSCAN]
@1 @12 @13
(0 IIAN
@4 @15 @18
Press
813 07 @18 @19
813
dFT@2O@
BANK
2
DAft"
DLY SRCH.
?'888.888 11Hz
/. .."-
5 KHI NFII