Filter
Top Products
7. On the base unit, pull the handset
retainer out of the slot. Rotate it
clockwise 180 degrees.
8. Flip the retainer from front to back.
Slide it back into the slot so that the
lip of the retainer is up and the
▼ is
down. The retainer holds the handset
in place.
▼ Direct wall mounting
If you don’t have a standard wall plate, you can mount your phone directly to the
wall. Before doing this, consider the following:
• Select a location away from electrical cables, pipes, or other items behind the
mounting location that could cause a hazard when inserting the screws into
the wall.
• Mount your phone near a working phone jack to avoid excessive cord lengths.
• Make sure the wall material is capable of supporting the weight of the base and
the handset.
1. Insert two #10 mounting screws (with 1-3/8 inches
minimum length and the appropriate anchoring
device) into the wall 3-15/16 inches apart. Allow
about 3/16 of an inch between the wall and screw
heads for mounting the phone.
2. Refer to steps 1 through 8 on page 6 and 7 to
mount the telephone.
7
Before you plug the other
end of the telephone cord
into the modular jack on the
wall, charge the battery (See
Charging the Battery Pack,
page 9).
Be careful not to insert the
mounting screws into
possible electrical hazards
such as cables, wiring,
or pipes.
EXS9995 11/9/00 15:54 Page 7