Filter
Top Products
1. Plug the AC adapter cord into the 10V DC input jack on the back of the base.
2. Wrap the AC adapter cord around the strain relief notch.
3. Plug the AC adapter into a standard 120V AC wall outlet.
4. Charge the battery (refer to Charging the Battery Pack, page 9).
5. Plug one end of the long telephone cord into the
TEL LINE 1/2 jack on the back
of the base.
6. Plug the other end of the cord into the telephone jack on the wall.
7. Set the base on a desk or tabletop.
Place the handset on the base with the
keypad either facing up or down. Raise
the antenna to a vertical position.
5
DESK/TABLETOP INSTALLATION
Before using your phone,
charge the Nickel-Cadmium
battery pack for 15-20 hours.
Place the power cord so that
it does not create a trip
hazard or where it could
become chafed and create a
fire or electrical hazard.
Use only the Uniden AC
adapter supplied with this
phone. DO NOT use an
outlet controlled by a
wall switch.
EXS9995 11/9/00 15:54 Page 5