Filter
Top Products
▼ Dialing from Standby Mode
1. Pick up the handset.
2. Use one of the memory features. (See Using Memory Dialing, page 32).
3. Press
line 1.
4. When you finish the call, press
line 1, or return the handset to the base.
17
USING THE TONE FEATURE
FLASH AND CALL WAITING
You may enter a pause
in the dialing sequence
during Standby Mode.
You may not enter a pause
in the dialing sequence
during Talk Mode.
The tone feature applies only
when the base is set to pulse.
The flash feature does not
function when
line 1 and
line 2 are on a conference
call. (See the 3-WAY
CONFERENCING and 4-WAY
CONFERENCING, pages 21
and 22.)
If you are dialing in the pulse mode and
need to enter tone digits, press tone then
enter the digits. Once the call has ended, tone
mode is canceled and pulse dialing resumes.
If you have Call Waiting service and a call
waiting tone sounds, press
flash to accept the
call. After a short pause you will hear the new
caller. To return to the original caller, press
flash again.
EXS9995 11/9/00 15:54 Page 17