Filter
Top Products
You can operate your answering system from a remote location using any touch-tone
telephone. Use this function to check for recorded messages, to play or delete
messages, even to record a new greeting message, and to monitor sounds in the room.
1. Call your telephone number. (Either
line 1 or line 2)
2. During the answering machine is activated, press
# and your PIN code.
3. The answering system announces the time and day stamp and the number of
messages stored. Then the message playback automatically begins.
4. You may continue to listen to your message, or you may select a command from
the following chart.
51
REMOTE ACCESS AWAY FROM HOME
You can check both line
messages by calling either
line 1 or line 2.
You must enter a command
within 15 seconds of entering
command waiting mode or
the answering system
automatically hangs up and
returns to standby.
The system will only
playback messages for four
minutes and then it returns
to command waiting mode.
To continue playing your
message, press # then 2
again within 15 seconds.
Command Function
# then 1 Repeat
# then 2 Playing your messages
# then 3 Skipping a message
# then 4 Deleting a message
# then 5 Stop message playback
# then 6 Answering system On/Off
# then 7 Record Greeting
# then 8 Review Greeting
# then 9 Line Select
# then 0 Room monitor
5. After all of your messages have played, or the playback time exceeds 4 minutes,
you will hear that the intermittent beeps indicating that the system is in the
command waiting mode. You may enter another command at this time from the
chart above.
6. When you finish, hang up to exit the system. The answering system
automatically returns to standby.
You can only operate one line at a time. When you press # then 9,
“set to message on 1 (or 2)” will be announced and back to step 3.
EXS9995 11/9/00 15:55 Page 51