Uniden 986-2 Cordless Telephone User Manual


 
ADDITIONAL INFORMATION[ 44 ] www.uniden.com
Case
If the handset or either charging
cradle is exposed to moisture or liquid,
but the liquid only affects the exterior
plastic housing.
If moisture or liquid has entered the
plastic-housing (i.e. liquid can be
heard in the phone or liquid has
entered the handset battery
compartment or vent openings on the
either charging cradle).
Action
Wipe off the liquid, and use as normal.
Handset:
1. Remove the battery cover and leave it off for ventilation.
2. Remove the battery pack by disconnecting.
3. Leave the battery cover off and the battery pack disconnected for at least 3 days.
4. Once the handset is completely dry, reconnect the battery pack and the battery cover.
5. Recharge the handset’s battery pack for 20 hours in either charging cradle before using the
phone.
Charging cradle:
1. Disconnect the AC adapter from the charging cradle cutting off electrical power.
2. Disconnect the telephone cord from the charging cradle.
3. Let dry for at least 3 days.
IMPORTANT: You must unplug the telephone line while recharging the battery pack to
avoid charge interruption.
CAUTION:
DO NOT use a microwave oven to speed up the drying process. This will cause permanent
damage to the handset, charging cradle and the microwave oven.
After following these steps, if your cordless telephone does not work, please send to:
Uniden America Corporation
Parts and Service Division
4700 Amon Carter Blvd.
Ft. Worth, TX76155
1-800-554-3988. Monday through Friday
8 a.m. to 5 p.m. CST
Liquid Damage
Moisture and liquid can damage your cordless phone. In case of accidental submersion, please read the
following steps.
UC427ZH (DXI986-2) 10/20/03 10:53 AM Page 44